Filter
Top Products
44
Ⅵ Alarm Output
Item
Function/Set Value
This section describes the setting procedures for alarm output.
Set Values : ON, OFF
Select the alarm output method.
Output OFF: Output alarm signals when the Alarm Output 1
or Alarm Output 2 terminal is connected to the
GND terminal.
Output ON : Output alarm signals when the Alarm Output 1
or Alarm Output 2 terminal and the GND terminal
are disconnected from each other.
Level : Continue output of alarm signals throughout the
alarm input process.
Momentum : Output alarm signals only at the specified time.
Specify time using the Return Interval item.
For setting the output interval when the Output Pattern item is
set to Momentum.
This is disabled when the Output Pattern item is set to Level.
Upon pressing the Output button, alarm signal output will be
sent from the alarm output terminal on the ceiling mount.
This is used for checking the alarm operation.
Initial Value
OFF
—
—
—
—
6
Output 1/
Output 2
Output Value
Pattern
Interval
7
Output 1
force output/
Output 2
force output
2-4 Other Settings Using the "VN-C205U Setup Tool" (4. Alarm Setting) (Continued)
Settings (Step 2 Network Settings)
Ⅵ Other Triggers
Item Function/Set Value
For setting alarm operations when motion is detected within
the area specified in the motion detection settings.
*Please refer to the [Alarm 1/2] item for details on the set val-
ues.
Initial Value
—
*
Please
refer to
the [Alarm
1/2] item
for the
initial
values.
5
Motion Detection
• Mode
• Alarm Output
•
Message Packet
• Alarm FTP
Note
• Output is disabled when the Output Pattern item is set
to "Level".
45
2-4 Other Settings Using the "VN-C205U Setup Tool" (5. Recording Setting)
● When an alarm is activated, recording can be performed via "local recording", where camera
images are saved into a CF card, or via the V.Networks Controller, where these are saved into the
hard disk of the PC. (
☞
Page 67)
This function is used to perform settings for local recording, which records camera images to
the CF card when the alarm is activated. Please purchase the CF card separately. (
☞
Page 19)
● Setting the [Trigger Recording] screen
1.
Start up the "VN-C205U Setup Tool" and select [Recording]. To make new values
effective, click on [Apply], followed by [OK].
1
Select alarm input signal “Trigger” for starting local
recording.