Filter
Top Products
11-7
11
Flash
Setting Up the SB-28D or SB-28DX
Whenever you mount the SB-28D on your camera, the Flash mode is automatically set to
Auto Aperture mode.
The Mode indicator on the Speedlight’s LCD panel shows A.
If the f-stop indicator on the Speedlight’s LCD panel flickers and the indicator bars
disappear, the f-stop is out of usable range. Choose a different aperture.
1 Press the ZOOM button to set
the Zoom setting at the same (or
wider) f-mm as that of the lens
in use.
In the automatic Zoom setting,
the flash beam coverage always
follows the picture field angle of
the lens in use. The ZOOM
button allows you to change the
flash beam coverage. Refer to
the SB-28 instruction manual.
2 Set the Exposure compensation
level to zero EV or to the desired
level. Refer to the SB-28D
instruction manual.
The compensation level is shown
at the upper right of the
Speedlight’s LCD panel.
SELMODEZOOM
ISO
ZOOM
mm
m
181396431.510.6 0.8 2
FLASH
ON / OFF
A
STBY