Filter
Top Products
2-6 A-61169 July 2003
Scanning documents
Before you scan documents, be sure the menu bar is displayed on the
Operator Control Panel.
Documents must be fed under both feed module tires. For faster
throughput, feed documents into the elevator tray in landscape orientation
(longer side as the leading edge).
To start scanning:
1. Enable the scanner from the host.
2. Place the documents to be fed in the elevator tray.
3. Press Start/Resume.
NOTES:
• Documents must be fed under both feed module tires.
• Do not lean on the elevator tray and/or document extenders while the
scanner is running. If this happens, the elevator tray may make some
noise and stop in position. See the Problem Solving Chart in Chapter
6, Troubleshooting/Messages for procedures on recovery from this
situation.
• Use caution when feeding small documents; small documents may
fall through the slots of the elevator tray and cannot be easily retrieved.
To stop scanning:
• Press Stop/Pause.
Operator Control
panel
Start/Resume
Stop/Pause