Filter
Top Products
3-12 A-61169 July 2003
4. Select Return.
5. Use the up and down arrows to select the desired SCSI termination
setting.
6. Select Return.
7. Turn the scanner off. Wait at least 10 seconds and turn the scanner
back on again. The new termination setting will take effect.
Setting the elevator tray
position
This setting allows you to select a position of the elevator tray. Elevator
positions can be set to accommodate 25-, 250-, 500-, 750- or 1000-
documents (20-lb bond paper). The position will remain as selected
unless the Override Elevator icon ( ) is selected.
NOTE: The setting of 25 should be used for manual or continuous feed
operation.
To set the elevator tray position:
1. Select the Diagnostics Settings menu icon.
2. Use the right or left arrow to navigate to the Settings function.
3. Press the down arrow until Set elevator position is displayed on the
Operator Control Panel.