Filter
Top Products
3-2 A-61169 July 2003
Enabling and disabling
the scanner
The five buttons at the bottom of the Control Panel correspond to the
icons above the buttons To activate the icons, press the corresponding
button.
Enabling the scanner The scanner can only be enabled from the host computer. When the
scanner is enabled, you can change the image address level, override the
elevator setting and use the programmable keys. When enabled, the
icons on the Operator Control Panel will look like this:
These functions can be performed when the scanner is enabled:
Increments the image address level. Depending on the image
address level the icon may appear as follows:
indicating the next image address is level 3
indicating the next image address is level 2
indicating the next image address is level 1
Lowers the elevator tray if it is not already in the lowest position.
Performs the first programmable function.
Performs the second programmable function.
Performs the third programmable function.
NOTE: Programmable keys are set-up during application setup. Check
with your system administrator for the function of each
programmable key. Possible programmable key assignments
are as follows:
• No scanner functionality (default)
• Scanner End-of-Job
• Terminate Batch
• Omit Multi-feed Detection on Next Document
• Omit Printing on Next Document
• Omit Patch Reading on Next Document
Icons
Control panel
buttons