Filter
Top Products
109
Pictures are
not sharp.
Make sure the subject is within
the autofocus range (p. 26).
A special situation is pre-
venting the autofocus sys-
tem from focusing (p. 27).
Use the focus-lock function to
focus on an object at the same
distance as the subject (p. 26).
Pictures are
taken indoors
or in low-light
situations with-
out flash.
Slow shutter speeds
result in blurred images
when the camera is hand-
held.
Use a tripod, change the cam-
era sensitivity to a higher set-
ting (p. 51), or use the flash (p.
36).
The subject is beyond the flash range (p.
28).
Move closer to the subject or
change the camera sensitivity
to a higher setting (p. 51).
Problem Symptom Cause Solution
Focus signal is
red.
While using
flash, the pic-
tures are too
dark.
Shutter will
not release.
Card-locked
warning
appears on the
monitor.
Memory card is locked.
Unlock the memory card using
the write-protect switch (p. 19).
Subject is too close.
If the camera does not function normally, turn it off, remove and reinsert the battery, or unplug and
reconnect the AC adapter. Always turn the camera off using the main switch otherwise the memory
card may be damaged and camera settings reset.