Konica Minolta Dimage X20 Digital Camera User Manual


 
39
Used for self-portraits, the self-timer will delay the release of the shutter for approximate-
ly ten seconds after the shutter-release button is pressed.The self-timer drive mode is
selected in the drive mode on the main menu of the recording-mode (p. 34).
With the camera on a tripod, compose the picture as described in the
basic recording operation section (p. 25). Focus lock (p. 26) can be used with off-
center subjects. Press the shutter-release button partway down to lock the expo-
sure and focus (1). Press the shutter-release button all the way down to begin the
countdown (2). Because focus and exposure are determined when the shutter-
release button is pressed, do not stand in front of the camera when setting a self-
timer image. Always confirm the focus with the focus signals before beginning the
countdown (p. 27).
A countdown timer is displayed on the monitor. During the countdown, the indica-
tor lamp on the front of the camera (3) will start to blink and is
accompanied by an audio signal. A few seconds before the expo-
sure, the indicator lamp will blink rapidly. The lamp will glow
steadily just before the shutter fires.
To stop the countdown, press the up/down keys of the controller
or the menu button.The drive mode will be reset to single-frame
advance after the exposure.The audio signal can be turned off in
the section 1 of the setup menu (p. 86).
Self-timer
1
2
3