Filter
Top Products
20 21Getting up and running
INSTALLING AND REMOVING A MEMORY CARD
An SD Memory Card or MultiMediaCard must be inserted for the camera to operate. If a card has
not been inserted, a no-card warning is displayed on the monitor. For more about memory cards,
see page 108.
Always turn off the camera and confirm the indicator lamp is not lit before changing the
memory card, otherwise the card may be damaged, and data lost.
1. Slide the card-chamber door toward the front of
the camera to release the safety catch; the door
springs open.
2. Insert the memory card all the way into the card
slot and then release. The card should catch in
the slot.
Insert the card so the face is toward the back of
the camera. Always push the card in straight,
never at an angle. Never force the card. If the
card does not fit, check that it is orientated cor-
rectly. If a MultiMediaCard is inserted incorrect-
ly, it will lock, but the card chamber door will
not close.
3. To eject a memory card, press the card into the slot and release.
The card can now be pulled out.
4. Close the card-chamber door and slide it toward the camera to
engage the safety catch.
Images can be taken without a card. Depending on the file size,
one or more images can be stored temporarily and played back
once. These images cannot be transfered or saved.
TURNING THE CAMERA ON
To turn the camera on, press the main switch. When the camera is
initially turned on, the date and time need to be set, see the fol-
lowing page.
Press the main switch again to turn off the camera. Always store
and transport the camera off.
2
1
3