Konica Minolta X1 Digital Camera User Manual


 
7776 Setup mode
The flash mode is reset to aut-
oflash or autoflash with red eye
reduction depending on which
of those two flash modes were
last used.
AUTO RESET
When auto reset is active, the following functions reset when the camera is turned off. This function
can be turned off in section 1 of the setup menu (p. 73).
Flash mode (p. 28)
Drive mode (p. 40)
White balance (p. 46)
Camera sensitivity (p. 48)
Metering mode (p. 49)
AF area (p. 32)
Monitor display (p. 30)
Autoflash
Single-frame advance
Auto
Anti-Shake (p. 47) Exposure
Auto
Multi-segment
Wide focus frame
Full display
LANGUAGE
The language used in the menus can be changed. The language is selected in section 1 of the
setup menu (p. 73).
AUDIO SIGNALS
Every time a button is pressed, an audio signal gives a positive
confirmation of the operation. The audio signals can be turned off
in section 2 of the setup menu (p. 73). Two audio signals are avail-
able.
FOCUS SIGNAL
When the shutter-release button is pressed partway down, an audio signal confirms the AF system
has focused. The focus signals can be changed or turned off in section 2 of the setup menu (p. 73).
Two tones are available.
SHUTTER FX
When the shutter is released, a shutter sound effect will give a positive confirmation of the opera-
tion. The sound effect can be changed or turned off in section 2 of the setup menu (p. 73). Two
shutter effects are available.
VOLUME
The volume of the audio signals and shutter FX can be increased or decreased in section 2 of the
setup menu (p. 73). This affects the camera’s audio signals only and will not change the playback
levels of an audio track.
Audio signals
Focus signal
Shutter FX
Volume
Power save
1
1
1
2
3 min.
AUTO POWER SAVE
To conserve battery power, the camera shuts down if an operation is not made within a certain peri-
od. To restore power, press any button. The length of the auto-power-save period can be changed
in section 2 of the setup menu (p. 73): 1, 3, 5, 10, and 30 minutes. The length of the auto-power-
save period is fixed at 10 minutes when the camera is connected to a computer or PictBridge print-
er.
Exposure compensation (p. 50) 0.0
Hibright LCD (p. 52) Off
Sharpness (p. 53)
Contrast (p. 54)
Normal
Normal
Color mode (p. 52) Color