Chapter 3 LEDs, DIP Switches, and Connectors
© National Instruments Corporation 3-3 NI 1450 Series Compact Vision System User Manual
Figure 3-2. ACT/LINK and 100 Mbps LEDs
DIP Switches
This section describes the SAFE MODE, IP RESET, NO APP, and
USER 1 DIP switches on the NI 1450.
To enable a DIP switch, move it to the ON (left) position and then reset the
NI 1450 by pressing the RESET button for at least two seconds.
Note You must reset the NI 1450 in order for the setting change to occur.
NI 1454
Compact Vision System