Filter
Top Products
239
Technical Notes—Caring for the Camera
Replacing the Clock Battery
The camera clock is powered by a CR1616 lithium battery with a life of about
four years. When the clock battery is exhausted, a
icon will be dis-
played in the top control panel while the exposure meters are on. When a
icon blinks in the top control panel while the exposure meters are on,
Photographs can still be taken but will not be stamped with the correct time
and date, and interval timer photography will not function correctly. Replace
the battery as described below.
1
The clock battery chamber is located on the roof of the main battery
chamber. Turn the camera off and remove the EN-EL4 battery.
2
Slide the clock battery chamber cover toward
the front of the main battery chamber.
3
Remove the clock battery.
CR 1616
3V
D
C
I
N
4
Insert new CR1616 lithium battery so that the
positive side (the side marked with “+” and
the battery name) is visible.
CR 1616
3V
D
C
I
N
CR 1616
3V
D
C
I
N
5
Slide the clock battery chamber cover towards
the back of the main battery chamber until it
clicks into place.
6
Reinsert the EN-EL4.
CAUTION
Use only CR1616 lithium batteries. Using another type of battery could cause an ex-
plosion. Dispose of used batteries as directed.
Inserting the Clock Battery
Insert the clock battery in the correct orientation. Inserting the battery incorrectly
could not only prevent the clock from functioning but could damage the camera.
Setting the Time and Date
Be sure to set the time and date after replacing the clock battery ( 19).