Filter
Top Products
Measurement units (m/ft)
119
Settings
7
2 Press ac to set the year, then
press d to move to the month
setting.
• To move back to the previous setting,
press b.
• The first two digits of the year are fixed.
3 Repeat this procedure until the
date and time are completely set.
• The time is displayed in the 24-hour
format. Consequently, 2 p.m. is displayed as 14:00.
4 Press N.
• For a more accurate setting, press N when the time signal hits 00 seconds.
The measurement unit can be selected from either meters or feet in the
manual focus mode.
m At long ranges, the camera measures in meters, and at short ranges in
centimeters.
ft At long ranges, the camera measures in feet, and at short ranges in inches.
Top menu [MODE MENU] [SETUP] [m/ft] [m] / [ft]
g“Menus” (P.16)
Note
• The date and time settings will be returned to the factory default settings if the
camera is left without the battery for approximately 3 days. The settings will be
canceled more quickly if the battery was only loaded in the camera for a short
time before being removed. Before taking important pictures, check that the
date and time settings are correct.
• If the date and time setting is canceled, a warning is displayed on the monitor
the next time the camera is turned on. g“Error codes” (P.158)
2005
.
01 01
00 00
:
.
GO
OK
SET
SELECT
Measurement units (m/ft)
Mode dial
d4250_e_00_0_bookfile.book Page 119 Friday, December 24, 2004 11:45 AM