Filter
Top Products
94
6
Playback
Recording sound
Sound can be added to a still picture that you have already taken. (This is
known as “after-recording”.) You can also re-record over the sound that
has already been recorded. Total recording time per picture is
approximately 4 seconds.
Select the still picture to which you want to add sound.
Top menu [MODE MENU] [PLAY] [R] g“Menus” (P.16)
1 Press d to display [START].
2 Aim the camera microphone
toward the sound you want to
record and press N to start
recording.
• The [BUSY] bar is displayed during
recording.
Note
• If the microphone is farther than 1 m (3.3 ft.) from the subject, sound may not
be recorded properly.
• If you re-record the sound, the original sound is erased.
• You may not be able to record sound when there is insufficient card memory
(the “CARD FULL” message is displayed).
• Sound recording may pick up camera noises, such as button operation or
shutter movement.
• Once sound is added to a picture, it is not possible to erase only the sound. In
this case, make a re-recording with silence.
Mode dial
START
EDIT
CARD
SET
PLAY
Microphone
d4250_e_00_0_bookfile.book Page 94 Friday, December 24, 2004 11:45 AM