Filter
Top Products
Troubleshooting
164
10
Appendix
Pictures you have taken do not appear on the monitor.
The power is off. Set the mode dial to q, then press the
POWER switch to turn the camera on.
P.12
The camera is in the
shooting mode.
Press the QUICK VIEW button or set the
mode dial to q.
P.12,
13
There are no pictures on
the card.
“NO PICTURE” is displayed on the monitor.
Record pictures.
–
There is a problem with
the card.
See “Error codes”. P.158
The camera is
connected to a TV.
The monitor does not function when the AV
cable is connected to the camera.
P.98
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
Display pictures with 9 and press the 0
button to cancel protection.
P.102
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
Set the video output signal according to the
region where used.
P.99
The TV video signal
setting is incorrect.
Set the TV to the video input mode. P.98
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
Select [s] and adjust the brightness. P.117
The monitor is exposed
to direct sunlight.
Block the sunlight with your hand or use the
viewfinder.
–
Possible cause Corrective action
Ref.
page
d4250_e_00_0_bookfile.book Page 164 Friday, December 24, 2004 11:45 AM