Filter
Top Products
109
VQT2S62
Advanced (Recording pictures)
When [AUTO REGISTRATION] is set to [ON], the registration screen will display
automatically after taking a picture of a face that has a high number of appearances.
•
Registration screen is displayed after approximately 3 pictures. (It is not counted when
Burst
Mode
, Auto Bracket, White Balance Bracket, Multi Film Bracket or [AUDIO REC.] is set.)
• It may be extremely hard to recognize only with [AUTO REGISTRATION], so register the face
images with [FACE RECOG.] in the [REC] Mode menu beforehand.
∫ Registering from the automatic registration screen
1 Press 3 to select [YES] and then press [MENU/SET].
•
If there are no registered persons, proceed to step 3.
• Selection screen is displayed again when [NO] is selected, and
when [YES] is selected with
3, [AUTO REGISTRATION] will be
set to [OFF].
2 Press 3/4 to select [NEW PERSON] or
[ADDITIONAL IMAGE] and then press [MENU/SET].
•
After additionally registering or changing a face image, the screen returns automatically to
the recording screen.
3 Perform the operation in Step 6 and following in “Registering face image of new
person”.
Note
•
If the registration screen will not display, it may display easier by recording in the same
conditions or with the same expressions.
• If a face is not recognized even though it is registered, it will make the recognition easier by
registering the person again using the [FACE RECOG.] in the [REC] Mode menu in that
environment.
• If the registration screen is displayed for a person that is already registered, it will make the
recognition easier by additionally registering.
• It may make recognition harder when a picture recorded with flash is registered.
Auto Registration
Item Description of settings
[NEW PERSON]
• A list of registered people is displayed when there are 6 people
already registered. Select the person to be replaced.
[ADDITIONAL IMAGE]
To additionally register a face image for a registered person.
Press 3/4/2/1 to select the person to whom you wish
add the picture, and then press [MENU/SET].
•
If 3 images have already been registered, the picture
replacement screen will appear. In this case, select the picture
you wish to replace.
DMC-G10KPP-VQT2S62_eng.book 109 ページ ２０１０年４月２３日 金曜日 午後８時０分