Filter
Top Products
VQT2S62
144
Advanced (Playback)
Note
•
The number of prints can be set from 0 to 999.
• With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this is the case.
• It may not be possible to use the print settings with other equipment. In this case, cancel all the
settings, and reset the settings.
• If the file is not based on the DCF standard, the print setting cannot be set.
• [PRINT SET] cannot be set for pictures that were taken with the [QUALITY] set to [ ].
You can set protection for pictures you do not want to be deleted by mistake.
Select [PROTECT] on the [PLAYBACK] Mode menu. (P28)
Press [‚] to return to the menu screen.
• Press [MENU/SET] to close the menu.
∫ Canceling all the [PROTECT] settings
1 Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET].
2 Press 3 to select [YES] and then press [MENU/SET].
3 Press [MENU/SET] to close the menu.
•
If you press [MENU/SET] while canceling protection, the canceling will stop halfway.
Note
•
The protect setting may not be effective on other equipment.
• Even if you protect pictures on a card, they will be deleted if the card is formatted.
• Even if you do not protect pictures on a card, they cannot be deleted when the card’s
Write-Protect switch is set to [LOCK].
P [PROTECT]
Press 3/4 to select [SINGLE] or [MULTI] and then
press [MENU/SET].
Select the picture, and then
press [MENU/SET].
When [MULTI] has been selected
•
Repeat these steps for each picture.
• The settings are canceled when
[MENU/SET] is pressed again.
[SINGLE] [MULTI]
Press 2/1 to select
the picture.
Press 3/4/2/1 to
select the pictures.
DMC-G10KPP-VQT2S62_eng.book 144 ページ ２０１０年４月２３日 金曜日 午後８時０分