Filter
Top Products
VQT2S62
46
Basic
In Program AE Mode, you can change the preset aperture
value and shutter speed without changing the exposure.
This is called Program Shift.
You can make the background more blurred by
decreasing the aperture value or record a moving subject
more dynamically by slowing the shutter speed when
taking a picture in Program AE Mode.
1 Press the shutter button halfway and display the aperture value and shutter
speed value on the screen.
2 While the values are displayed (about 10 seconds), perform the Program Shift
by rotating the rear dial.
•
It will switch between Program Shift operation and Exposure Compensation operation (P63)
every time the rear dial is pressed while the values are displayed.
• Rotate the rear dial to display the [EXPO.METER] B. (P127)
• The Program Shift indication A appears on the screen when Program Shift is activated.
• To cancel Program Shift, turn the camera off or rotate the rear dial until the Program Shift
indication disappears.
∫ Example of Program Shift
(When the 14–42 mm/F3.5–5.6 lens included in DMC-G10K is used)
Note
•
If the exposure is not adequate when the shutter button is pressed halfway, the aperture value
and shutter speed turn red and blink.
• Program Shift is canceled and the camera returns to normal Program AE Mode if more than
10 seconds pass after Program Shift is activated. However, the Program Shift setting is
memorized.
• Depending on the brightness of the subject, Program Shift may not be activated.
• Program Shift is not possible when the [SENSITIVITY] is set to [ ].
Program Shift
(A): Aperture value
(B): Shutter speed
1 Program Shift amount
2 Program Shift line chart
3 Program Shift limit
A B
(A)
(B)
4 2 1 1
/
2
1
/
4
1
/
8
1
/
15
1
/
30
1
/
60
1
/
125
1
/
250
1
/
500
1
/
1000
1
/
2000
1
/
4000
15
16
17
18
19
20
(Ev)
2
2.8
4
5.6
8
11
16
22
1
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14
DMC-G10KPP-VQT2S62_eng.book 46 ページ ２０１０年４月２３日 金曜日 午後８時０分