119
VQT1J42
With a computer
Connection and recognition
After the software applications are installed, this
unit must be connected to the computer and be
correctly recognized by the computer.
≥
Connect after installing the software applications.
≥
Remove the supplied CD-ROM if it is inserted in
the computer. (If the [Setup Menu] screen is
displayed, wait until it finishes and then remove
the CD-ROM.)
≥
If the recognition procedure is not accomplished
properly, operation will not be possible after
connecting the unit to the computer.
≥
If the unit fails to operate normally, it may mean
that you have not conducted the installation or
recognition procedure properly.
≥ Be sure to finalize all discs other than
DVD-RAM before using them with a
computer. Un-finalized discs cannot be
recognized by the computer.
1 Connect this unit to the AC
adaptor.
≥ If a battery is used, operation is not possible
when this unit is connected to a computer.
2 Insert a disc or card with
recorded images in the unit, then
turn on the unit.
3
Connect this unit and a computer.
A USB cable (supplied)
The USB function selection screen will appear.
≥ Insert the plugs as far as they will go. The unit
and computer will not operate properly if the
plugs are not inserted fully.
≥ Do not use any other USB connection cables
except the supplied one. (Operation is not
guaranteed with any other USB connection
cables.)
4 Select [PC CONNECT (DISC)] or
[PC CONNECT (CARD)] and then
press the cursor button.
This unit is automatically recognized by the
computer.
≥ When the unit is connected to a computer,
the operation mode cannot be changed and
its power cannot be turned off.
Disconnect the USB cable, before turning
this unit off. (l 121)
≥ (STD mode) If the unit is connected to a
computer when the USB function is set to
[PC CONNECT (DISC)], no image will appear
on the LCD monitor or the viewfinder.
≥ When this unit is connected to a computer, you
cannot use this unit’s DISC EJECT lever to
remove a disc.
≥ Do not disconnect the USB cable or AC
adaptor while the ACCESS/PC lamp is on or
card access icon appears on the LCD
monitor. Doing so may damage the data on the
disc or card.
≥ It may be necessary to reboot the computer
after connecting this unit to it for the first time.
Camera–Computer connection
VQT1J42ENG.book 119 ページ 2007年7月20日 金曜日 午前10時36分