Filter
Top Products
48
VQT1J42
Setup
To exit the menu screen
Press the MENU button.
≥ The menu screen does not appear during
recording or playing. You cannot start other
operations while the menu screen is displayed.
The menu screen transition is the same as when
the buttons on the main unit are used.
1 Press the MENU button.
2 Select a menu item.
≥ Use the direction buttons (3,4,2,1) and
ENTER button in place of the cursor button on
the main unit.
3 Press the MENU button to exit
the menu screen.
Setting date and time
When the unit is turned on for the first time, a
message asking you to set the date and time will
appear.
≥ Move the cursor button to select [YES], press
the cursor button and then perform steps 2 and
3 below to set the date and time.
¬Rotate the mode dial to select or
.
1 Press the MENU button, then
select [BASIC]
# [CLOCK SET] #
[YES] and press the cursor
button.
2 Move the cursor button left or
right to select the item to be set.
Then, move the cursor button up
or down to set the desired value.
≥ The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥ The 12-hour system is used to display the time.
3 Press the cursor button to enter
the selection.
≥ The clock function starts at [00] seconds when
the cursor button is pressed.
≥ Press the MENU button to finish the setting.
Check the date and time displayed.
Remote control operation
MENU
MENU
ENTER
MENU
ENTER
MENU
ENTER
VQT1J42ENG.book 48 ページ ２００７年７月２０日 金曜日 午前１０時３６分