Filter
Top Products
40
VQT1J42
Setup
ª Identifying recording/playback
sides of disc
A “SIDE A” mark
B The opposite side is the “SIDE A” recording/
playback side.
Single sided disc/dual layer on single side
disc:
The recording/playback side is opposite to the
labelled side.
Double sided disc:
The “SIDE A” recording/playback side is the side
opposite the side with the “SIDE A” mark.
The “SIDE B” recording/playback side is the side
with the “SIDE A” mark.
≥ Do not use excessive force when opening the
cover.
≥ Do not touch the pickup lens or the recording/
playback side of the disc.
This may impair recording and playback.
≥ Insert the disc securely to prevent damage.
≥ When you open the cover, the ACCESS/PC
lamp flashes. Do not leave the cover open.
≥ If the cover is open, the power will not turn off
even if the Mode dial is set to OFF.
≥ If the disc is not correctly inserted, the cover
will not close. Never try to forcibly close the
cover. This could cause damage. Reinsert the
disc properly.
≥ If a single sided disc is inserted into the unit
with the printed label facing the inside, an error
message will appear. Remove the disc and
reinsert it with its recording/playback side
facing the inside.
≥ Do not allow the recording/playback side to
become dirty or scratched.
≥ Do not remove the battery pack or disconnect
the AC adaptor while removing the disc or until
power is completely turned off. If you do, the
cover will not open. If this happens, reattach
the battery pack or reconnect the AC adaptor,
slide the DISC EJECT lever once, and then
release it. A repair disc message may be
displayed when the power is turned back on.
(l 137)
≥ Do not insert anything other than the 8 cm (3z)
DVD-RAM, DVD-RW, DVD-R or DVD-R DL
disc into the disc compartment. Doing so could
cause malfunctions. (l 26)
≥ Do not touch the pickup lens or other parts
inside the disc compartment. Be sure not to
touch the area around the pickup lens as it can
become extremely hot.
Inserting/removing an SD
card
Be sure to set the mode dial to OFF before
inserting/removing an SD card.
1 Set the mode dial to OFF.
≥ Check that the status indicator has gone off.
2 Open the card slot cover.
D
V
D
-
R
A
M
/
S
I
D
E
A
A
B
After inserting a disc/After recording
finishes
While the ACCESS/PC lamp is lit, the disc is
rotating and disc information is being
recorded. If the power supply is interrupted at
this time, the disc may become unusable. Do
not disconnect the AC adaptor or remove the
battery. Also, do not shake or bump into the
unit while the lamp is on.
If the SD card is inserted or removed while
the power is on, this unit may malfunction
or the data recorded on the SD card may
be lost.
VQT1J42ENG.book 40 ページ ２００７年７月２０日 金曜日 午前１０時３６分