Filter
Top Products
38
VQT1J42
Setup
Quick start
When quick start is ON the battery power is still
being consumed, even when the LCD monitor
and the viewfinder are closed.
This unit will resume recording/pause mode
about 1.7 seconds after the LCD monitor or the
viewfinder are reopened.
≥ When in quick start standby mode, about
70% of the power used in recording pause
mode is being consumed so the recording
time will be reduced.
≥ This is only activated in the following case.
sWhen the mode dial is set to and an
SD card is inserted.
1 Press the MENU button, then
select [SETUP]
# [QUICK START]
# [ON] and press the cursor
button.
2 Close the LCD monitor and
retract the viewfinder while the
mode dial is set to .
The status indicator A flashes green and the unit
goes into quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor or extend
the viewfinder.
The status indicator A lights red and the unit is
put into recording pause approx. 1.7 seconds
after it is turned on.
ª To cancel Quick start
Press the MENU button, then select [SETUP]
# [QUICK START] # [OFF] and press the
cursor button.
≥ The status indicator goes off, the lens cover
closes and the power turns off if the mode dial
is set to OFF while the unit is in quick start
standby mode.
≥ The status indicator goes off and the power
turns off if quick start standby mode continues
for approx. 5 minutes.
≥ Quick start standby mode is canceled, if
jthe mode dial is switched
jthe battery is removed or the AC adaptor is
disconnected
≥ In the quick start mode, it may take some time
for automatic white balance to adjust, if the
scene being recorded has a light source
different from the scene last recorded. (When
the MagicPix function is used, however, the
white balance of the scene last recorded is
retained.)
≥ In the quick start mode, the zoom
magnification becomes 1k and the picture size
may differ from what it was before quick start
standby mode.
≥ If [POWER SAVE] (l 131) is set to
[5 MINUTES] and the unit automatically goes
into quick start standby mode, close the LCD
monitor and then open it again.
MENU
VQT1J42ENG.book 38 ページ ２００７年７月２０日 金曜日 午前１０時３６分