Filter
Top Products
31
VQT1J42
Setup
Setup
Charging the battery
When this unit is purchased, the battery is not
charged. Charge the battery before using this unit.
≥ Refer to page 32 concerning batteries that
can be used with this unit.
1 Connect the AC cable to the AC
adaptor and the AC outlet.
≥ Remove the DC cable beforehand.
2 Put the battery on the battery
mount by aligning the mark, and
then securely plug it in.
≥ The output plug of the AC cable is not
completely connected to the AC adaptor jack.
As shown in A, there is a gap.
ª Charging lamp
Lights up:
Charging
Goes off:
Charging completed
Flashing:
Make sure that the terminals of the battery or the
AC adaptor are not exposed to dirt, foreign
objects or dust, then reconnect them properly.
Disconnect the AC cable from the AC outlet
when you remove dirt, foreign objects or dust on
the terminals of the battery or the AC adaptor.
If the charging lamp is still flashing, something
may be wrong with the battery or AC adaptor.
Contact your dealer.
≥ Battery charging time (l 32)
≥ We recommend using Panasonic batteries
(l 10, 32, 159).
≥ If you use other batteries, we cannot guarantee
the performance/quality of this product.
Inserting/Removing the
battery
Push the battery against the battery
holder and slide it until it clicks.
While sliding the BATTERY lever,
slide the battery to remove it.
≥ Hold the battery with your hand so it does not
fall.
≥ Before removing the battery, be sure to set the
Mode dial to OFF and check that the status
indicator is off.
If the DC cable is connected to the AC
adaptor, then the battery will not charge.
Remove the DC cable from the AC adaptor.
A
Inserting the battery
Removing the battery
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
VQT1J42ENG.book 31 ページ ２００７年７月２０日 金曜日 午前１０時３６分