Filter
Top Products
Others
137
VQT1J42
It is possible that the system cannot complete writing of a file normally when, for example, power is
turned off for some reason during recording or editing.
If faulty management information is found when a disc or an SD card is accessed, the following
message may appear. (Repairing may take time depending on the error.)
¬HD mode
When connecting to AC adaptor or the remaining capacity of the battery is enough:
[FINISHED.]
When the remaining capacity of the battery is low:
[CANNOT REPAIR CONTROL INFORMATION DUE TO LOW BATTERY POWER.]
When connecting to AC adaptor or the remaining capacity of the battery is enough:
[THUMBNAIL DATA HAS BEEN REPAIRED SUCCESSFULLY.]
When the remaining capacity of the battery is low:
[CANNOT REPAIR CONTROL INFORMATION DUE TO LOW BATTERY POWER.]
¬STD mode
≥ Use a sufficiently charged battery or the AC adaptor.
≥ Depending on the condition of the data, it may not be possible to completely repair the data.
≥ If the recovery fails, you will no longer be able to playback the data recorded before the power went
off.
≥ When data recorded on another device is recovered, it may not be possible to play back the data on
this unit or the other device.
≥ If the thumbnail information is recovered, displaying the thumbnails may become slower.
CANNOT SET.
The [GUIDE LINES], [ZEBRA], [MF ASSIST], [MIC LEVEL] and
[RED EYE] menu settings cannot be set when the color bar is set.
DISCONNECT USB
CABLE.
The unit cannot correctly establish the connection to the computer
or printer. Disconnect and then reconnect the USB cable.
(HD mode) DISCONNECT
USB CABLE.
The unit’s power cannot be turned off when the unit is connected to
the computer.
(STD mode) CANNOT
OPERATE WHILE
CONNECTED TO
COMPUTER.
About recovery
CONTROL DATA ERROR HAS BEEN
DETECTED.
THUMBNAIL DATA ERROR IS DETECTED.
DISC ERROR HAS OCCURRED. NOW
REPAIRING DATA ON THE DISC.
VQT1J42ENG.book 137 ページ ２００７年７月２０日 金曜日 午前１０時３６分