Filter
Top Products
41
VQT1J42
Setup
3 Insert/remove the SD card into/
from the card slot.
≥
When inserting an SD card, face the label side
A
upwards and press it straight in as far as it will go.
≥ When removing the SD card, press the center
of the SD card and then pull it straight out.
4
Securely close the card slot cover.
ª About the SD card
≥
Do not touch the terminals on the back of the SD card.
≥
Electrical noise, static electricity or the failure of this
unit or the SD card may damage or erase the data
stored on the SD card. We recommend saving the
important data recorded on this unit to a PC using
the USB cable (supplied), HD Writer 2.0E for SX/SD
etc. (
l
123) (We recommend using HD Writer 2.0E
for SX/SD to acquire data recorded on this unit.)
≥ When using an SD card on which data has
been written many times, the remaining time
left for recording may be reduced. (l 54)
ª Card access lamp [ACCESS]
≥ When this unit accesses the SD card (reading,
recording, playback, erasing, etc.), the access
lamp A lights up.
≥ When the lamp is lit, do not:
jRemove the SD card
jOperate the mode dial
jRemove the battery or disconnect the AC
adaptor
Performing the above while the lamp is on may
result in damage to data/SD card or this unit.
How to use the cursor button
This unit has a cursor button A for selecting
functions, performing operations, etc. so it is
easy to operate this unit with one hand.
B Operating the operation icons and menu
screens that are displayed
The following describes operations on the menu
screen and selection of files on the thumbnail
view screen, etc.
Move the cursor button up, down,
left, or right to select an item or
scene, and then press the cursor
button to set it.
1 Select by moving up.
2 Select by moving down.
3 Select by moving left.
4 Select by moving right.
5 Press the cursor button to set the item.
≥ Menu screen operations (l 47)
Basic operations
1
2
3
4
4
5
VQT1J42ENG.book 41 ページ ２００７年７月２０日 金曜日 午前１０時３６分