Filter
Top Products
49
VQT1J42
Setup
Changing the date and time display style
Press the MENU button, then select [SETUP] #
[DATE/TIME] # desired display style and press
the cursor button.
≥ You can also show or change the date and
time display by repeatedly pressing the DATE/
TIME button on the remote control.
Changing the display style
Press the MENU button, then select [SETUP] #
[DATE FORMAT] # desired display style and
press the cursor button.
≥ The date and time function are driven by a
built-in lithium battery.
≥ Make sure to check the time before recording.
≥ If the time display becomes [- -], the built-in
lithium battery has run down. Use the following
steps to charge the battery.
To recharge the built-in lithium battery:
Connect the AC adaptor or attach the battery to
the unit, and the built-in lithium battery will be
recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (The battery is still
being recharged even if the mode dial is set to
OFF.)
≥ When you turn on the power for the first time
after charging, a message asking you to set
the date and time will appear. Select [YES] and
set the date and time.
Adjusting LCD monitor/
viewfinder
1 Press the MENU button, then
select [SETUP]
# [LCD SET] or
[EVF SET]
# [YES] and press the
cursor button.
2 Move the cursor button up or
down to select the item to be
adjusted. Then, move the cursor
button left or right to make the
adjustment.
≥ (HD mode) Move the cursor button to select
the item to be adjusted. Then, press the center
of the cursor button to set and then move the
cursor button to make the adjustment.
The bar display moves.
≥ (HD mode) After adjustments are made if no
operations are performed for about 2 seconds,
the bar will disappear.
≥ Press the MENU button to exit the menu
screen.
[LCD SET]
[BRIGHTNESS]:
Brightness of the LCD monitor
[COLOR]:
Color level of the LCD monitor
≥ When the viewfinder is extended and the LCD
monitor is rotated by 180° towards the lens, the
brightness and color level of the LCD monitor
cannot be adjusted.
[EVF SET]
[BRIGHTNESS]:
Brightness of the viewfinder
≥ To adjust the brightness of the viewfinder,
extend the viewfinder and close the LCD
monitor to activate it.
[DATE] [D/T]
[OFF]
Display style Screen display
[Y/M/D] 2008. 1. 1
[M/D/Y] JAN 1 2008
[D/M/Y] 1. 1.2008
JAN 1 2008 12:34PMJAN 1 2008
Adjusting the brightness and
color level
VQT1J42ENG.book 49 ページ ２００７年７月２０日 金曜日 午前１０時３６分