Filter
Top Products
Others
145
VQT1J42
ª When connected to another device
Problem Check points
“PUSH THE RESET
SWITCH.” or “CHECK
THE DISC AFTER
PUSHING THE RESET
SWITCH TO REPAIR THE
DISC.” is displayed.
≥ Is the disc scratched or dirty?
# After using the following method to restart the unit, eject the disc
and clean it. (l 30) If there are scratches on the disc, use a new
disc.
≥ The unit has automatically detected an error. Press the RESET
button with the projecting part of the grip belt A. This will restart the
unit.
≥ If you do not press the RESET button, the power to this unit is
turned off automatically about 1 minute later.
≥ Even after you press the RESET button, the indication may still
appear repeatedly. If so, this unit needs repair. Detach the power
connected, and consult the dealer who you purchased this unit
from. Do not attempt to repair the unit by yourself.
Problem Check points
EZ Sync does not work.
≥ Are you connecting with the component cable or the AV cable?
# Connect with a HDMI cable (optional). (l 103)
≥ Is the [EZ Sync] setting appropriate?
# Press the MENU button, then select [SETUP] > [EZ Sync] >
[ON] with the cursor button.
≥ Depending on HDMI terminal of the TV, the input channel may not
switch automatically. In this case, use the remote control for the TV
to switch input. (For details on how to switch input, please read the
operating instructions for the TV.)
≥ Check the EZ Sync setting on the connected device.
≥ Turn the power to the unit off and then back on again.
≥ Set [EZ Sync] to [Off] on the TV and then turn it back to [On]. (Refer
to the operating instructions of the TV for details.)
≥ Are you using pictures recorded in STD mode?
# Use pictures recorded in HD mode.
VQT1J42ENG.book 145 ページ ２００７年７月２０日 金曜日 午前１０時３６分