Filter
Top Products
98
VQT1J42
Disc and card management
¬Rotate the mode dial to select or
and then select the [ ] tab.
Press the MENU button, then select
[DISC SETUP] or [SETUP]
#
[AUTO PROTECT] # [ON] and press
the cursor button.
≥ This function’s default setting is [ON].
≥ We recommend that the auto protect function
is set to [ON] in order to prevent accidental
deletion on other devices. If discs recorded on
this unit are inserted into other devices without
protecting them, a message may be displayed
prompting you to format the disc. If the disc is
formatted, the data on it will be erased, and the
process cannot be reversed.
≥ If a disc with no recorded motion pictures is
ejected, it will not be protected.
ª To release the disc protection
Erase all the motion pictures on the disc or
format the disc.
≥ Please be aware that if a disc is formatted,
then all the data recorded will be erased and
cannot be recovered.
≥ The disc will need to be re-formatted on the
device you will use.
Disc protection setting
This is for preventing recorded contents from
being deleted or edited by mistake.
Further recording and editing is not possible on
protected discs until the protection is released.
¬Rotate the mode dial to select .
1 Press the MENU button, then
select [DISC SETUP] #
[DISC PROTECT] and press the
cursor button.
2 When the confirmation message
appears, select [YES], then press
the cursor button.
To release disc protection
1) Press the MENU button, then select
[DISC SETUP] # [DISC PROTECT] and
press the cursor button.
2) When the confirmation message appears,
select [YES], then press the cursor button.
≥ If the disc has been protected on another
device, it may not be possible to release the
protection on this unit. In this case, release the
protection on the device that you used to
protect it.
MENU
MENU
VQT1J42ENG.book 98 ページ ２００７年７月２０日 金曜日 午前１０時３６分