Filter
Top Products
39
VQT1J42
Setup
Inserting/removing a disc
The cover of the disc compartment will not open
unless the unit has a charged battery or is
connected to the AC adaptor.
1 Attach the battery or connect the
AC adaptor.
2 Slide the DISC EJECT lever up
and release it.
A few moments after the ACCESS/PC lamp A
blinks, the cover of the disc compartment will
open slightly.
3 Open the cover of the disc
compartment and insert/remove
the disc.
Inserting disc
Place the disc onto the spindle in the center and
then push the disc down until it clicks into place.
A Recording/playback side
B Pickup lens (Reads disc)
C Press until it clicks.
≥ Be careful not to touch the recording/playback
side of the disc when inserting/removing it.
Removing disc
While pressing down on the spindle, grasp the
edge of the disc and gently lift it out.
4 Push the section marked
PUSH CLOSE on the cover of the
disc compartment to close the
cover.
≥ When using new DVD-RAM or DVD-RW
(l 27)
≥ When inserting a disc recorded on another
device or in another mode (l 27)
≥ You cannot remove a disc while recording
motion pictures on an SD card or in PRE-REC.
(l 55)
DISC
EJECT
ACCESS
/PC
VQT1J42ENG.book 39 ページ ２００７年７月２０日 金曜日 午前１０時３６分