Filter
Top Products
186
Using the Flash
5
Wireless Flash Control (P-TTL Flash Mode)
When using external flash units (AF540FGZ or AF360FGZ) for
wireless shooting, the following information is exchanged between
the flash units before the flash is discharged.
Press the shutter release button fully.
È
1 The flash directly connected to the camera emits a control flash
(relays the flash mode of the camera).
2 The wireless remote flash emits a test flash (relays confirmation
of subject).
3 The flash directly connected to the camera emits a control flash
(relays flash output to the wireless remote flash).
* The flash directly connected to the camera will emit a control flash one
more time after this to relay the flash duration time when HSb (High-
speed sync) is set.
4 The wireless remote flash discharges as the main flash.
When the wireless mode of the external flash directly connected to the
camera is set to [MASTER] or [17. Flash in Wireless Mode] (p.184) is set
to [On] for the built-in flash, all the flashes will discharge simultaneously.
Red-Eye Reduction
As with the built-in flash, the red-eye reduction function is available
with an external flash. However, this function may not be available on
some flashes or may have restrictions for usage conditions. Refer to
the chart on p.180.
• The red-eye reduction function works by discharging the flash twice
even when only an external flash is used. (p.79)
• If the red-eye reduction function of the built-in flash is used when the
external flash is set as the slave unit or with the wireless function, the
pre-flash for red-eye reduction will trigger the external flash. Do not use
the red-eye reduction function when using a slave unit.