Filter
Top Products
English _11
INSTALLING THE BUTTON-TYPE BATTERY
Installing the button-type battery in the remote control
1. Turn the battery holder counterclockwise (as indicated with (
) mark) using your
fingernail or a coin to open it. The battery holder opens.
2. Insert the battery into the battery holder with the positive (+) terminal facing down and
press it firmly until you hear a locking sound.
3. Place the battery holder back in the remote control, match its (
) mark with the (
)
mark on the remote control, and turn the battery holder clockwise to lock it.
Precautions regarding the button-type battery
• There is a danger of explosion if button-type battery is incorrectly replaced. Replace
only with the same or equivalent type.
• Do not pick up the battery using tweezers or other metal tools. This will cause a short
circuit.
• Do not recharge, disassemble, heat or immerse the battery in water to avoid the risk
of explosion.
WARNING
Keep the button-type battery out of the reach of the children.
Should any battery be swallowed, consult a doctor immediately.
USING THE CRADLE
The cradle is a connection plate which can be used to make the
camcorder more stable when charging the battery, or connecting to
an external device (TV, PC, etc.).
• If you connect your HD camcorder to the provided cradle
using more than one type of cable to output image, the order
of priority of the output signal is as follows:
USB cable
Component /Multi-AV cable.
• Do not connect the connection cables at the same time, it
may cause conflict and may not work properly.
If this occurs, remove all the connected cables and try the
connection again.
Battery
holder
1
2
3
DC IN jack
USB jack Component/Multi-AV
jack
Cradle
receptacle