Filter
Top Products
24
Remote Operation
Installing batteries
Two R6 (size AA) batteries (not supplied)
7.1 IR Remote Commander Unit
Remote Operation
7
The following provides information on the function and location of the parts.
1
CAMERA SELECT buttons
Press the button corresponding to the camera
you want to operate with the IR Remote
Commander Unit. The camera number can be
set using the IR SELECT switch on the rear of the
camera.
FOCUS buttons
Used for focus adjustment. Press the AUTO
button to adjust the focus automatically. To
adjust the focus manually, press the MANUAL
button, and adjust it with the FAR and NEAR
buttons.
DATA SCREEN button
Press this button to display the Main menu. Press
it again to turn off the menu. If you press the
button when a lower-level menu is selected, the
display goes back to a higher-level menu.
PAN/TILT buttons
Press the arrow buttons to perform panning and
tilting. Press the HOME button to face the
camera back to the front. When the menu is
displayed, use V or v to select the menu items
and B or b to change the set values.
2
3
4
1
2
3
4
5
6
7
8
9
10
If two or more cameras are adjacent and have
the same camera number, they are operated
simultaneously with the same IR Remote Com-
mander Unit. If you are installing cameras close
to each other, make sure you allocate a different
camera number to each one.
Note
5
6
7
8
To avoid risk of explosion, use R6 (size AA)
manganese or alkaline batteries.
Caution
9
10
L/R DIRECTION SET button
Hold down this button and press the REV button
to change camera movement to the opposite
direction indicated by the arrow of the B/b
buttons. To reset the camera movement
direction, press the STD button while holding
down this button.
POWER switch
Press this button to turn on/off the camera
when the camera is connected to an AC outlet.
BACK LIGHT button
Press this button to enable the Backlight
Compensation function. Press it again to
disable Backlight Compensation.
POSITION buttons
Hold down the PRESET button and press a
number button from 1 to 6 to store the current
Camera Direction, Zoom, Focus Adjustment,
and Backlight Compensation setting in the
memory of the pressed number button. To erase
this memory, hold down the RESET button and
press the same number button. For the
BRC-H700 and BRC-Z700, preset positions from 7
to 16 are not available.
PAN/TILT RESET button
Press this button to reset the pan/tilt position.
ZOOM buttons
Use the SLOW button to zoom slowly, and the
FAST button to zoom quickly. Press the T
(telephoto) side of the button to zoom in, and
the W (wide angle) side to zoom out.
Pan/tilt and zoom operations are disabled when
the menu is displayed.
Note