Filter
Top Products
28
Remote Operation
If the STANDBY lamp of the camera flashes
When the camera is moved or turned by hand or
by external shock, the microcomputer inside the
camera my not be able to memorize the pan/tilt
position properly. To reset the pan/tilt position,
press the PAN/TILT RESET button.
The setting above only changes the signal emitted
from the RM-BR300 Remote Control Unit, and does
not change any camera settings.
Note
Movement of the
camera
Setting
Incline to the right.
While holding down
Press.
Incline to the right.
While holding down
Press.
Joystick
STANDBY flashes.
Zooming
Turn the dial on the upper part of the joystick.
Subject appears
farther away.
(Wide angle)
Subject appears
closer. (Telephoto)
When you perform a pan/tilt operation with a
camera in Telephoto mode, the screen image may
move at an uneven speed.
Note
The Backlight Compensation function is not effective
if the mode is set to MANUAL in the camera’s
EXPOSURE menu.
Backlight Compensation function
When you shoot a subject with a light source
behind it, press the BACK LIGHT button. To cancel
this function, press the BACK LIGHT button again.
Adjusting the camera
Focusing on a subject
To focus the camera on a subjec
automatically
Press the AUTO/MANUAL button so that the AUTO
Indicator lights.
The camera focuses on the subject in the center of
the screen automatically.
To focus the camera on a subject manually
Press the AUTO/MANUAL button so that the
MANUAL Indicator lights. Then turn the FOCUS
control clockwise or counterclockwise to make the
camera focus on the subject.
One-push auto focusing during manual
focus adjustment
Press the ONE PUSH AF button. The camera focuses
on the subject in the center of the screen
automatically.
MODE
BACK LIGHT
ONE PUSH AWB
VALUE/R
BRIGHT/B
FOCUS
AUTO/MANUAL
ONE PUSH AF
SHIFT
Focusing on a far
subject
Focusing on a near
subject
Note
Note