Filter
Top Products
26
Remote Operation
Improved functionality with the
RM-BR300/5
The following feature can be achieved with the
RM-BR300/5 and after.
ON-Air Tally Mode
On-Air Tally Mode is newly incorporated to the
RM-BR300/5. You can set the On-Air Tally Mode
by taking the following steps:
1. Press the On/Off switch to turn off the
RM-BR300/5
7.2.2
Operation
The following information enables easy camera system operation with the benefit of functions such as
pan/tilt/zoom operation, preset memory, and more.
Before operating, check that the camera, the
RM-BR300 Remote Control Unit, and peripheral devices are properly installed and connected.
Note
Turning on the power
1
2
PANEL LIGHT
POWER CAMERA
RESET
1 Connect the camera to an AC outlet using the
supplied AC power adaptor and power cord.
When the power is turned on, the POWER lamp
lights. The camera will automatically pan and tilt,
and be reset to the position stored in POSITION 1
(Pan/Tilt Reset action).
2 Press the ON/OFF switch on the RM-BR300
Remote Control Unit to turn it on.
3 Turn on the peripheral devices.
Model Name Destination Serial No.
RM-BR300/5 Remote Control Unit UC7 120001-
RM-BR300/5 Remote Control Unit J1 320001-
RM-BR300/5 Remote Control Unit CE3 420001-
1 2 3 5 74 6 8
Switcher
Camera 1: Tally on
RM-BR300/5
Camera 1: Controllable
Camera 1
Tally lamp is on
Camera is controllable
Camera 4
Tally lamp is off
Camera is controllable
Camera 2 Camera 3
Tally out
VISCA
Tally/Contact
1 2 3 5 74 6
2. Set the Tally/Contact switch to Tally
3. Press the On/Off switch to turn on the unit,
while simultaneously holding down the
Mode button, Camera button 4, and
Position button 4
When On-Air Tally Mode is selected, the tally
lamp of the camera lights up depending on
the selected port of the Tally/Contact connector
on the RM-BR300/5, regardless of the camera
selection on the RM-BR300/5. For example, if
you press camera 1 on the switcher, camera 4
on the RM-BR300/5 remains unchanged. This is
because the switcher and the RM-BR300/5
operate independently in this mode.
The tally lamp of camera 1 will light up, and
camera 4 will remain controllable.