Filter
Top Products
2-1
HDW-F900 P1E2
Section 2
Service Overview
PWH2.6 x 5
PWH2.6 x 5
CN141 CN142 CN10
CN140
Harness (MB-APR)
Screws with stopper
Screws with stopper
Screw
with stopper
Flexible
card wire
Screw with stopper
Strap
Screws with stopper
Joining link
Screw with stopper
Screw with stopper
Flexible card wire
Flexible card wire
Loosen the two screws fully and remove the front lid.
(Stoppers are provided for these screws.)
1. Remove the front lid.
2. Loosen the four screws fully and remove the outside panel.
(Stoppers are provided for these screws.)
Front Lid
Outside Panel
Loosen the four screws fully and turn the inside panel in the arrow direction.
(Stoppers are provided for these screws.)
Disconnect the three flexible card wires from the connectors
(CN140, 141, 142).
Disconnect the harness (MB-APR) from the connector (CN10).
Remove the strap screw (PWH2.6 x 5).
Remove the joining link screw (PWH2.6 x 5).
Inside Panel
2.
3.
4.
5.
1.
*
*
A
How to disconnect
Slide the two sections marked * of the connector in the
direction of the arrow (white), and disconnect the flexible
card wire.
How to connect
Connector
Conductor side
Blue (Insulator side)
Flexible card wire
Lift the two sections marked * of the connector in the
direction of arrow A, and insert the flexible card wire fully.
Push in the two sections marked * of the connector in the
direction of the arrow (black).
1.)
2.)
2-1. Removal and Installation of Exterior Parts