Filter
Top Products
5-6
HDW-F900 P1E2
5-5. Registering Reference Files
5-5. Registering Reference Files
This file can be stored and read using the setup menu or MSU (master setup unit). Only one file can be
stored, and will be stored in the camera and memory stick.
As for the items to be stored, refer to Section 5-8,“ File Items”.
For reference files, differential data taking the factory-setting as 0 will be stored. Therefore, initializing
the reference file brings the settings to the same status at factory-setting.
(*1)
Using the setting menu, all
items or specified items can be initialized.
Reference files can be copied between cameras using the memory stick.
(*1) : If lens files or OHB file retains the data, those need to be initialized as well.
m
. As for the setup menu, refer to Section 4.
. Before storing the file in the memory stick, make sure that the LOCK switch on the memory stick is in
OFF position.
Storing Using the Setup Menu (Refer to step 1 of Fig.5-4.)
Set the setup menu as follows.
[FILE] → [REFERENCE] → [STORE|FILE]
The data will be stored in the camera and the numerical data will be displayed as 0. (Excluding some
items. Refer to Section 5-8. “File Items”.) If the memory stick is inserted into the camera, the data will
also be stored in the memory stick at the same time.
Storing by MSU (Refer to step 1 of Fig.5-4.)
Set the MODE switch to FILE and press [REFERENCE] and then press [REF|STORE]. The data will
be stored in the camera and the numerical data will be displayed as 0. (Excluding some items. Refer to
Section 5-8. “File Items”.) If the memory stick is inserted into the camera, the data will also be stored in
the memory stick at the same time.
Calling Using the Setup Menu (Refer to step 2 of Fig. 5-4, Fig. 5-1.)
Set the setup menu as follows.
[PAINT] → [SCENE|FILE] → [STANDARD]
The temporary paint amount and scene file amount will be cleared and the reference file will be reset to
the state stored in.
Calling with MSU (Refer to step 2 of Fig. 5-4.)
Press the “STANDARD” switch to reset the reference file item to the state stored in.