Filter
Top Products
2-16
HDW-F900 P1E2
M1.4 x 2.5
M1.4 x 1.6
Stopper plate
Stopper plate
Side plate
assembly
Stage
Figure 1
Stage assembly
Antenna flexible board
Antenna flexible board
(FL-260)
Antenna sheets (A)
M1.4 x 2.5
M1.4 x 2.5
M1.4 x 2.5
Antenna
flexible board
(FL-260)
Cassette compartment assembly
Mechanism deck
assembly
*
The frame of the unit is not shown in the figure.
2-6. Cassette Compartment Assembly
Removal and Installation
n
After turning off the power, perform removal and installa-
tion of the cassette compartment assembly following the
procedures below.
[Reference][Reference]
[Reference][Reference]
[Reference]
The cassette compartment can be removed both in raised
and lowered status.
Removal
1. Remove the front lid and the outside panel.
(Refer to Section 2-1.)
n
Even a slight bend causes a short life of the flexible
board, therefore use extreme care to handle it.
2. Disconnect the antenna flexible board FL-260 from the
CCM-33B board of DC-DC converter and remove it.
(Refer to Section 2-7.)
3. Remove the three screws and hold the portion of the
cassette compartment shown in the figure, then remove
the cassette compartment in the arrow direction.
2-6. Cassette Compartment Assembly Removal and Installation
Installation
n
Before installing a new cassette compartment, remove then
reattach the two antenna sheets (magnetic sheet) and
reattach the antenna flexible board FL-260.
1. Remove the two screws from a side plate assembly of
a new cassette compartment to remove the stopper
plate.
2. Route the antenna flexible board FL-260 (M1.4 x 1.6)
as shown in the figure and combine the antenna
flexible board with the two antenna sheets (A), then
attach them to the stage assembly. (Refer to Figure 1.)
3. Install the stopper plate with the two screws.