Filter
Top Products
Basic Operation Procedure
28
Recording
Preparations
1 Mount a fully charged battery pack.
2 Load SxS memory card(s).
If you load two cards, recording is continued
by automatically switching to the second
card when the first card becomes full.
3 Adjust the angle of the LCD monitor for
the best view.
When you wish to use the EVF, fold the LCD
monitor to its park position and adjust the
angle of the EVF.
4 Set the power switch to the ON position.
The recording screen is displayed.
When using the remote commander, activate the
remote control mode (page 21).
Note
When you hold the camcorder by the grip, support it
from underneath with your left hand.
Recording (Full Auto mode)
5 Press the FULL AUTO button so that
the button indicator lights.
Full Auto mode is turned on, activating the
TLCS (Total Level Control System) (page
73). Thus Auto Exposure, AGC (Auto Gain
Control), Auto Shutter, ATW (Auto Tracing
White) are set to ON, whereby the brightness
and white balance will be automatically
adjusted.
When you wish to adjust them manually, turn
Full Auto mode off, and see;
“Exposure” on page 32
“Gain” on page 31
“Electronic Shutter” on page 32
“White Balance” on page 30
AF (Auto Focus) is not activated by setting the
camcorder to Full Auto mode.
For information of automatic focus adjustment,
see “Focus” (page 33).
Recording
Basic Operation Procedure
REC START/STOP
REC REVIEW (on the grip)
SxS memory card slots
Power switch:
ON (the " position)
LCD monitor
angle
adjustment
Battery pack insertion
FULL AUTO
3
1
2
8
4
6, 7
5
Note