Filter
Top Products
Program Configuration
VBrick H.264 Appliance Admin Guide 55
Announce Settings
This section contains parameters that are used to modify announcements from the appliance.
Announcements are advertisement packets that are transmitted by VBrick appliances to other
VBrick appliances and VBrick applications such as the EtherneTV Portal Server and
StreamPlayer. They are used to identify streams present in the network.
External Announce Settings
These settings configure an external announcement that can be used when the stream is
reflected to a third-party server or a (future) VBrick reflector.
RTCP Transmit Interval If RTCP Transmit is enabled, this setting tells the appliance
how often (in seconds) to send the reports. Default = 10
seconds.
Announce This section is used to announce the RTSP streams to the local
network allowing viewable RTSP announcements in programs
like StreamPlayer. The unit must be on the same segment of the
network or the router must be configured to retransmit
broadcast packets for the announcements to be accessible using
the IP address 255.255.255.255.
Use Global Announce IP
and Port
Use Announce IP Address for Servers and Announce Port
defined on Program Configuration > Global page. If checked,
the Destination and Port fields are greyed out.
Destination IP Address The destination IP address the announcement is sent to. By
default, the announcement is sent to the multicast network. If
using an EtherneTV Portal Server, enter the Portal Server IP
address.
Port The destination port the announcement is sent to.
External Announce This section is used to announce RTSP streams to a network
device outside of the broadcast domain.
Use Global Announce IP
and Port
Use Announce IP Address for Servers and Announce Port
defined on Program Configuration > Global page. If checked,
the Destination and Port fields are greyed out.
Destination IP Address The destination IP Address or Host Name the announcement is
sent to. If using an EtherneTV Portal Server, enter the Portal
Server IP address. If using a reflector, enter the reflector server
IP address.
Port The destination port the announcement is sent to.
URL The URL of the reflector (i.e the source of the reflected
stream). This URL is embedded in the announcement.