Filter
Top Products
3
Chapter 3 Recording and Playback3-44
12 To end the menu operation, set the MENU ON/OFF switch to OFF
or close the cover of the menu operating section.
The menu disappears from the viewfinder screen and the message
“MANU INTERVAL *FRAME”, indicating the single trigger mode
of the Manual Interval Rec mode, appears along the bottom of the
viewfinder.
*FRAME indicates the number of frames set in step 6.
The display indicating the current status of the camcorder appears
along the top and bottom of the viewfinder.
Note
The settings for the single trigger mode of the Manual Interval Rec mode
are maintained until changed. However, if you switch the camcorder
power off, Manual Interval Rec mode settings are cleared except for the
NUMBER OF FRAME setting and the single trigger mode selection. To
use the single trigger mode of the Manual Interval Rec function again
after switching on the power, perform steps 1 to 2.
Camcorder operation in the single trigger mode of the
Manual Interval Rec mode
Follow the procedure below to shoot a picture in the single trigger mode
of the Manual Interval Rec mode.
Note
When you use cassettes on which nothing is recorded, such as brand new
cassettes, be sure to record color bars for more than 2 seconds at the
beginning of a cassette.
1 After performing the basic procedure for shooting and recording
following the instructions in “3-2-1 Basic Procedures” (page 3-6) ,
secure the camcorder so that it will not move.