Filter
Top Products
4
Chapter 4 Adjustments and Settings for Recording 4-75
4-7-4 Setting the Marker Display
Use the MARKER page of the USER menu to switch the display of the
center and safety zone markers on or off and to select whether the area
indicated by the safety zone marker is 80%, 90% or 100% of the screen
area.
Note
When an HKDW-702 is installed and the NTSC viewfinder and/or the
NTSC monitor are connected, all markers and zebra patterns are not
displayed if DOWN CON MODE is set to CROP on the OUTPUT SEL
page of the USER menu, even if the marker display is set to ON.
1 Set the MENU ON/OFF switch to ON.
The page that was on the screen when the last menu operation ended
appears on the viewfinder screen.
2 Turn the MENU knob until the MARKER page appears, and push
the MENU knob.
MENU knob
MENU ON/OFF switch
CANCEL/PRST /
ESCAPE swtich
(Continued)