Filter
Top Products
Chapter 6 Maintenance
6
6-6
4 Set the DISPLAY switch to CTL.
5 Press the VTR START button and check the following points.
• The tape reels are turning.
• The counter indication is changing.
• The REC indicator in the viewfinder is on.
• The RF and SERVO indicators on the display panel are off.
6 Press the VTR START button again and check that the tape stops
and that the REC indicator in the viewfinder goes off.
7 Repeat the checks of steps 5 and 6, this time using the VTR button
on the lens.
If the REC SWITCH function is assigned to the ASSIGN 1 switch,
repeats the checks of steps 5 and 6, this time using the ASSIGN 1
button.
8 Press the RESET button and check that the counter display goes to
“00:00:00:00”.
9 Turn on the LIGHT switch and check that the display panel is
illuminated.
10Hold down the REW button to rewind the tape for a while, then
press the PLAY button. Check that the rewind and playback
functions operate normally.
11Press the STOP button and press the F FWD button. Check that the
fast forward function operates normally.
(2) Testing the automatic audio level adjusting
functions
1 Set the AUDIO IN CH-1 and CH-2 switches to FRONT.