Filter
Top Products
3
Chapter 3 Recording and Playback 3-45
2 Push the VTR START button on the camcorder or the VTR button
on the lens.
The camcorder starts recording in the single trigger mode of the
Manual Interval Rec mode. The TALLY indicator (green) in the
viewfinder flashes (2 flashes/second) and the message “MANU
INTERVAL *FRAME” flashes on the viewfinder screen.
Each time you press the VTR START button or VTR button, the
camcorder captures and stores the picture data of the preset number
of frames. The REC indicator (red) is on while the camcorder is
capturing the picture in the memory. The camcorder stores picture
data (for about 5 seconds) in memory, and actually records the
stored picture data on the tape. The tape runs intermittently.
To stop the recording in the single trigger mode
You can stop the recording in the single triger mode of the Manual Rec
Interval mode using the following two methods. However, the tape may
continue to run to record the picture data stored in the memory at the
instant the tape stopped.
• Press the EJECT button.
• Set the POWER switch to OFF.
Setting the continuous trigger mode
1 Follow the procedure in steps 1 to 9 in “Setting the single trigger
mode” on page 3-40.
(Continued)