Filter
Top Products
4
Chapter 4 Adjustments and Settings for Recording4-10
If the automatic white balance adjustment cannot be
made
If the white balance adjustment cannot be completed normally, an error
message will appear for about 3 seconds on the viewfinder screen (in
display mode 2 or 3).
Possible messages are listed below.
White balance adjustment error messages
Error message Meaning
WHITE : NG
LOW LEVEL
WHITE : NG
COLOR TEMP HIGH
WHITE : NG
COLOR TEMP LOW
WHITE : NG
TIME LIMIT
WHITE : NG
POOR WHITE AREA
WHITE : NG
LEVEL TOO HIGH
If any of the above error messages is displayed, retry the white balance
adjustment. If the error message occurs again, an internal check is
necessary.
For information about this internal check, refer to “Maintenance Manual”.
The white video level is too low. Either make open
the lens iris or increase the gain.
The color temperature is too high. Select a suitable
filter setting.
The color temperature is too low. Select a suitable
filter setting.
Adjustment could not be completed within the
standard number of attempts.
The white area could not be checked.
The white video level is too high. Either narrow the
lens iris opening or change the ND filter.