Filter
Top Products
103
Editing
E
Turning On the Analog-Digital Converter
1. Set the camcorder to
PLAY(VCR)•
mode.
Check the video input setting ( 66).
2. Press the MENU button and select [VCR SETUP]. Select [AV DV/ ],
set it to [ON] and press the MENU button.
Depending on the signal sent from the connected device, the conversion from
analog to digital signals might not work properly (e.g., signals that include
copyright protective signals or anomalous signals such as ghost signals).
For normal use, set [AV DV/ ] to [OFF]. If it is set to [ON], digital signals
cannot be input via the camcorder’s DV terminal.
We recommend powering the camcorder from a household power source.
Connecting the camcorder to the computer you can also use the analog-digital
conversion to transfer analog recordings to your computer as digital signals.
Analog-digital conversion can be performed also when connecting the
camcorder to the computer using the USB cable.
The required equipment and operation is the same as when Transferring Video
Recordings to a Computer ( 119), except for step 3: In this case set the
[AV DV/ ] to [ON]. Check the setting before connecting the camcorder to
the computer.
The analog-digital conversion may not operate properly depending on the
software and the specifications and settings of your computer.
MENU
(64)
VCR SETUP AV DV/
OPTURA 600_NTSC-E.book Page 103 Friday, June 3, 2005 9:27 AM