Filter
Top Products
38
Adjusting the Volume
When you use the LCD screen for playback, the camcorder plays back the sound via
built-in speaker. The speaker does not sound when you close the LCD panel. Use
headphones when using the viewfinder.
1. Set the camcorder to
PLAY(VCR)•
or
PLAY(VCR)•
mode.
2. Turn the SET dial up to increase the volume, and
down to lower the volume during playback.
• A volume bar appears for 2 seconds.
• You can turn off the volume completely by turning the SET dial
down until “OFF ” appears. Turn the SET dial up to increase
the volume again.
The speaker does not sound when headphones are connected to the camcorder.
You can also use headphones to check the sound while recording. Use the MENU
button to adjust the volume ( 67).
SET dial
Speaker
OPTURA 600_NTSC-E.book Page 38 Friday, June 3, 2005 9:27 AM