Filter
Top Products
128
Memory Card Operation
Printing
Editing
Problem Solution
Memory card cannot be
inserted.
Memory card was not facing the correct direction. Turn the
memory card over and reinsert it.
21
Memory card cannot be
recorded.
Insert a memory card. 21
Memory card is full. Replace the memory card or erase
images.
95
Memory card is not formatted. Format the memory card. 96
Image number reached maximum value. Set [FILE NOS.] to
[RESET] and insert a new memory card.
69
SD Memory Card is protected. Change the position of the
protect switch.
21
Memory card cannot be
played back.
Set the camcorder to
PLAY(VCR)•
mode. 37
Insert a memory card. 21
Image cannot be erased. Image is protected. Cancel the protection. 94
SD memory card is protected. Change the position of the
protect switch.
21
“ ” flashes red. Card error occurred. Turn off the camcorder. Remove and
reinsert the memory card. Format the memory card if flashing
persists.
96
Problem Solution
The printer is not operating
even though camcorder and
printer are correctly
connected.
1. Set the camcorder to
PLAY(VCR)•
mode.
2. Disconnect and reconnect the USB cable.
3. Turn off the printer and turn it back on.
–
Problem Solution
Dubbing via the camcorder’s
DV terminal does not work.
Set [AV DV/ ] to [OFF]. 66
Wrong signal format. Dubbing may work via the AV terminal.
Refer also to the instruction manual of the connected device.
–
OPTURA 600_NTSC-E.book Page 128 Friday, June 3, 2005 9:27 AM