Filter
Top Products
Switching between Flash Adjustment Settings (continued)
108
Compensating the Flash Output
In M mode or when [Flash Adjust] is set to [Manual], the flash output
can be controlled in three steps, starting from FULL, when shooting.
This setting is also active with slave flash photography where
multiple flashes are fired at the subject from different positions
because the pre-flash does not fire. When an externally mounted
flash is attached, its flash output can be controlled (Up to 1/16 from
Full, in 1/3 steps).
3
Press the FUNC. button or click the main dial.
z To cancel the compensation, return the setting to .
1
Press the FUNC. button, then select using the S
or T arrow on the omni selector.
2
Adjust the output using the main
dial or the W or X arrow on the
omni selector.
z You can shoot the image right after
selecting settings by pressing the shutter
button. The menu displays again after the
shot, allowing you to change the settings
easily.
3
Press the FUNC. button or click the main dial.