Filter
Top Products
C-3
Cisco UCS C210 Server Installation and Service Guide
OL-20887-02
Appendix
Enabling the Mezzanine Card RAID Controller in the BIOS
When using the supported mezzanine-style RAID controller cards, you must enable the ICH10R
controller in Enhanced mode.
Step 1 Make sure that a RAID cable is attached between the mezzanine card and the disk backplane.
Step 2 Boot the server and press F2 when prompted to enter the BIOS Setup utility.
Step 3 Select the Advanced tab, then Mass Storage Controllers Configuration.
Step 4 Set Onboard SATA Controller to Enabled.
Step 5 Set SATA Mode to Enhanced.
Step 6 Press F10 to save your changes and exit the utility.
Step 7 To set up a RAID configuration when using the mezzanine card, boot the server and press Ctrl-C when
prompted to start the WebBIOS utility.
RAID Controller Cabling
The RAID controller connectors in this server are shown in Figure C-1. The blue line indicates the
recommended cable routing path from the backplane to the possible controller locations.
Figure C-1 RAID Controller Connectors
1 Extender or expander backplane 3 Mezzanine card connector
2 Integrated RAID connector on
motherboard
4 LSI MegaRAID PCIe card connectors
1
2
3
4