Filter
Top Products
Setting Up Your Scanner
5
Unlock and Initialize the Scanner
Before connecting the scanner to a power source, you must release the transportation
lock on the back of the scanner. Before connecting the scanner to your computer,
follow the steps below to make sure the scanner is operating properly.
1. Slide the transportation lock to the right; this releases the scanner carriage.
2. Locate the AC adapter and power cord supplied with your scanner. Connect the
power cord to the AC adapter. Then connect the AC adapter to the DC inlet on
the back of the scanner.
3. Plug the other end of the power cord into an electrical outlet. The indicator light
on the front of the scanner starts flashing.
It is not possible to change the AC adapter’s voltage. If the label on the AC
adapter does not show the correct voltage for your country, contact your
dealer. Do not plug in the power cord.
4. Open the document cover so you can see the operation of the scanner during
initialization (startup).
transportation lock
DC inlet
basics.book Page 5 Monday, October 23, 2000 11:35 AM