DIVIDING MOVIES (EDIT - DIVIDE)
Yon can divide a scene into two parts.
To delete unnecessary portion of scene, first divide tile scene, and then delete the unnecessary
portion.
'1 Press the DISC NAVIGATION bntton.
2 Select the scene to be divided.
3 Press the MENU bntton.
4Choose, "Scene".
"Edit". "Divide" and
then press the _/||
button.
5 The "Divide Scene" Lt_,_ER{-3_EURN _RAM]
screen will appear: If
you are sure you want to divide the selected
scene, press the I_/1| button: The selected
scene will be played back.
If yon want to change the scene to be divided,
you can change it on this screen.
O When yon reach the
point where you want
to divide the scene,
press the SELECT
button.
ISe!ec Dvis on PO{M I
_ _ _002 R_M 00018 _ I
_!_E!iTER[iJC_NC_L I I
The status bar of
scene being played
back can be switched
off or on by pressing
the DISPLAY button
Note:
• If you press the MENU button before pressing the
I_/|| button in step 5, the submenu wiII appear (see
page 111)
• Search and frame advance are useful when
designating division points.
• Combining scenes that were divided wiII restore the
original scene (see page 113)
• If a special effect has been added to the original
scene, the "IN" effect witl be added to the first half of
scene, and the "OUT" effect, to the tatter half
• The division point may drift before or after the
designated point by approximately 05 seconds
• Since a scene with a skip set cannot be played back,
no division point can be specified: Release the skip
for the scene before dividing it
• ftthe division point is at a still, a message wilt appear,
but no division will be made.
• If the division point is at the start or end of a scene, a
message wilt appear, but no division will be made
• A movie scene whose recording time is 0.5 seconds
or less cannot be divided
• ft free space available on disc is insufficient, division
will not be possible: Delete unnecessary scenes
7 The screen for verifying
division will appear:
Choose "YES",and then
press the I_/|| button.
Choose "NO" to cancel
division.
After division, the "Divide Scene" screen will
be restored.
Repeat steps 5 7 to divide another scene.
8 Press the • button to quit.
112